fast drilling performance long cement board screws suitable for plastic

Spoon point: The shape of this screw point removes surface material as the screw is being inserted for faster insertion — spoon point cement board screws are ideally used for wood, light metal studs or thick cement board. Self-drilling point: A screw with a self-drilling point mimics the performance and ease of a drill bit. Cement board screws with a self-drilling point don’t require …

Vacuum brazed diamond tip for fast penetration and long tool life. Thin wall construction for rapid penetration and removal of chips. Exceptional performance when drilling non-ferrous materials including hard tile, granite, travertine, marble, plastics, cement board, fiberglass, decking, laminates, brick, paving, thin sheet metal, aluminum and more.

Fiber Cement-Board Screws • T-17 and Self-Drilling with Nibs, or Wings. Exterior Coated l Orange Woodworking Screws • Particle-Board Screws, Pocket-Hole Screws, Cabinet Screws, and Bugle-Head Sharp Point Screws. Bugle Head Coarse Thread, T-17 and Sharp Point. Zinc and Yellow Zinc Plated and Black Phosphate, l Dark Blue Concrete Screw Anchors

characteristics. AQUAPANEL ® Cement Board Indoor is resistant to mould growth and is therefore also suitable for use in areas where there is a high level of damp. Altogether, this robustness, resistance and reliability in performance makes AQUAPANEL® Cement Board Indoor perfect for both walls and ceilings in wet environments. 4 5 Features and ...

using self-drilling CSK screws of suitable length 25mm/38mm etc. at 200 mm centers, maintaining a gap of 2.0 mm between the boards. The screws are kept 15 mm or 1.5 times the thickness of the board, away from the edge and 40 mm from the corner. Stud dimension will be decided based on the height of the partition. T-JUNCTION DETAIL PLAN

Jan 28, 2020 · Here are a few guidelines: PILOT HOLES SHOULD BE 85% OF SCREW DIAMETER. PILOT HOLES SHOULD BE SLIGHTLY DEEPER THAN THE SCREW. SCREWS INTO THE FACE SHOULD MORE THAN AN INCH FROM THE EDGE. SCREWS IN THE EDGE SHOULD BE AT LEAST 2.5 INCHES FROM END. Don't Over-tighten Screws. When you screw into particle board, do it …